All of these can help prevent bacterial, viral and fungal diseases taking hold while keeping your plants in tip-top condition. Regular trims and pruning allow your plants to benefit from increased sunlight, better airflow and improved water delivery to the roots. Today, we are going to look closer at why you should trim your overgrown hedges, how to do it without killing them and what tools will work best. When combined with the best tools for the job, it becomes a pleasure rather than a pain. Hedge trimming requires a little bit of skill, knowledge and time to perfect. In essence, pruning and trimming are techniques which follow the natural processes of nature, only in a more controlled and managed way. Something that every gardener wants.įlowering hedges and trees will also experience prolonged flowering if the old flowers are removed before going to seed. By trimming each year, it encourages healthier, thicker and more symmetrical growth of your plants. See the “Carburetor Kit” section for instructions here.Pruning and trimming hedges is an essential gardening skill that involves removing the dead or overgrown stems, roots and branches on hedges, trees and shrubs. If this is the case, you may need to clean out a clogged or gummed up carburetor or replace some of the smaller parts by purchasing a carb kit. Some carburetors are fixed, meaning they have no adjustments. When you have the engine running at its best, the problem will be solved (note: this does require some experience and may take a few times to get it right). Next, at full throttle, turn the H screw clockwise to set the high idle. Then, start by turning the L screw clockwise to add more fuel and set the idle. Once the engine is running again, allow it to idle for about a minute. It may run a little rough at first, but it should start at these settings. Turn both screws in to shut off fuel then turn them the opposite direction 2 turns and start the engine. One should be marked L (low) and one marked H (high). You will also want to locate both idle screws on the carburetor. Adjusting these settings to lean out the fuel flow will solve the problem. Sometimes the adjustment screws are improperly adjusted and therefore the engine is not getting enough air. Next, check for any adjustment screws that the carburetor may have. At this point you will want to look for any obstructions in the way that could block air flow, and ultimately starve the engine of oxygen. You will find the carburetor underneath the air filter, and once you have located it you can remove the air cleaner cap. A fouled or poorly adjusted carburetor can cause your hedge trimmer’s engine to idle, but die when power is increased.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |